FSPG Ablative Spray Coating

FSPG Ablative Spray Coating is to be used alongside the FSPG Batt system, to reinstate the fire resistance performance of wall constructions where they have been provided with apertures for the penetration of single or multiple services. FSPG Ablative Spray Coating can be applied with a brush or as a spray application.

Can be used in flexible walls, rigid walls and floors, with FSPG Batts.
Suitable for indoor use without additional environmental protection.
Remains flexible.
Suitable for large openings in walls and floor systems such as in combination with FSPG Batt.

EN 1366-3, EN 13501-1 and EN 13501-2
EN 10140, EN 1026 and EN 717-1
BS 476 20&22
1121-CPR-JA5021, ETA 14/0005
UL-EU-00771
Certifire CF513
BREEAM International Approved

Request Technical Data Sheets

For good adhesion the surfaces of the building elements shall be free of any dust or grease and may need to be primed. On good, clean virgin concrete & masonry, no priming required, though refer to substrate compatability requirements.
Ensure that the aperture and services in question are tested with FSPG Ablative Spray Coating and the site conditions are within the application specification.
Upon installation make sure that you install the minimum 140kg/m3 Stone Wool.
Fit around all services effectively, brush or trowel over the stone wool ensuring all joints and junctions are fully covered to the minimum required FSPG Ablative Spray Coating thickness.
Ensure FSPG Ablative Spray Coating Sealant is applied to a minimum:

DFT (Dry Film Thickness) of 1mm (2.5mm Wet Film Thickness).

Stone Wool minimum 140kg/m³may be pre coated off site, applying some FSPG Ablative Spray Coating to aid during installation. Ensure the correct thickness of FSPG Ablative Spray Coating is applied after site installation.

Refer to FSPG Batt for specific installation information.