FSPG Coating

FSPG Coating is an ablative coating applied to stone wool board to be used to reinstate the fire resistance performance of wall constructions where apertures exist with penetration of single or multiple services. FSPG Coating is an easy to apply highly viscous, or thick coating suitable to be applied by brush.

Can be brush or trowel applied.
Suitable for indoor use without additional environmental protection.
Remains flexible between -5^oC to +70^oC.
Easy to use fibre free coating.
Suitable for large openings in walls systems such as in combination with FSPG Batt.

EN 1366-3
EN 13501-2
EN 10140
EN 1026
1121-CPR-JA5022, ETA 14/0004
UL-EU-0517-CPR

Request Technical Data Sheets

For good adhesion the surfaces of the building elements shall be free of any dust or grease and may need to be primed. On good, clean virgin concrete & masonry, no priming required, though refer to substrate compatibility requirements.
Ensure that the aperture and services in question are tested with FSPG Coating and the site conditions are within the application specification.
Upon installation make sure that you install the minimum 140kg/m³ Stone Wool.
Fit around all services effectively, brush or trowel over the stone wool ensuring all joints and junctions are fully covered to the minimum required FSPG Coating thickness.
Ensure FSPG Coating Sealant is applied to a minimum:

DFT (Dry Film Thickness) of 1mm (2.5mm Wet Film Thickness).

Stone Wool minimum 140kg/m3 may be pre coated off site, applying some FSPG Coating to aid during installation. Ensure the correct thickness of FSPG Coating is applied after site installation.

Refer to FSPG Batt for specific installation information.