FSPG Intumescant Pipe Wrap

FSPG Intumescent Pipe Wraps are designed and tested to seal service penetration apertures containing plastic pipes formulated and thermoplastic composites based on reactive tumescent technology. The individual Pipe Wraps have been developed to provide a high volume expansion and pressure seal during a fire. The FSPG Intumescent Pipe Wraps can be used to a maximum diameter of 200mm. The ultra-thin design of FSPG Intumescent Pipe Wraps ensures that they can be installed into the tightest of locations.

FSPG Intumescent Pipe Wrap

Key Product Points

  • Fire resistance tested in flexible walls and rigid floors.

  • Tested with Plastic Pipes – PVC, HDPE, PP and PE.

  • Causes no known effects to plastic pipes.

  • Suitable for wall and floor installation and in FSPG Batt system.

  • The product is based on a thermoplastic composite and is therefore non-toxic.

  • Halogen free, contains no asbestos, ceramic or mineral fibres.

  • Not affected by fungus, vermin or rodents.

  • Can be used in areas of high humidity.

Certifications and Approvals

  • EN 1366-3

  • EN 13501-1

  • EN 13501-2

  • Etag 026 Type X

  • 1121-CPR-JA5081, ETA 15/0490

  • UL-EU-01022-CPR

  • Certifire CFS5369

  • UAE CerTificate of Compliance

Key Installation Points

  • For good adhesion the surfaces of the building elements shall be free of any dust or grease and may need to be primed. On good, clean virgin concrete & masonry, no priming required.

  • Ensure that the aperture and services in question are tested with FSPG Intumescent Pipe and the site conditions are within the application specification. An annular space needs to be present around the service to apply sufficient installation depth.

  • Make sure that you have the correct wrap size for the type and size of pipe.

  • Ensure where required or centrally within the wall that two wrap are used in the installation sealing of both sides.

  • Ensure when used in rigid floors that the wrap is installed as required in rigid floors, with regards to location of the wrap. Within the FSPG Compounds the wrap is installed centrally taking into account the correct wrap size for the type and size of the pipe.

  • Install the wrap into the wall around the service using the self adhesive strip leaving 5mm from the front face of the penetration seal, thus allowing the gap to be filled with FSPG Fire & Acoustic Acrylic to fill the 5mm gap. Ensure that this is done on both sides of the penetration seal.

Tools Used for Installation

Image icon
DUST PAN & BRUSH
Image icon
MASKING TAPE
Image icon
SPATULA
Image icon
PENCIL & RULER
Image icon
PLASTIC SHEET
Image icon
TAPE MEASURE
Image icon
GREEN WIPE
Interested in talking to us?