FSPG Pillows

FSPG Fire Pillows are an ideal product to create a temporary or permanent fire barrier around many types of services to prevent the passage of fire through a compartment wall or floor, especially suitable where services are continuously being changed or replaced. FSPG Fire Pillows are filled with organic filler and reactive intumescent additives in a PU glass cloth case.

Can be used in rigid walls & floors.
Can be used with Metallic Pipes, Cables, Cable Bunches, Cable Trays and Cable Ladders.
Reaction Temperature 180oC.
High Expansion Ratio.
Remains flexible between -20^oC to +130^oC.
Water resistant lining.
Suitable for locations up to 1m².
Non-combustible and non-toxic.
Ease of installation and long life.

EN 1366-3
EN 13501-2
EN 10140
EN 1026
EN ISO 13934-1
EN ISO 13935-1
BS 476
1121-CPR-JA5008, ETA 13/1056
UL-EU-00640-CPR
Certifire CF514

Request Technical Data Sheets

For good adhesion the surfaces of the building elements shall be free of any dust or grease and may need to be primed. On good, clean virgin concrete & masonry, no priming required.
Ensure that the aperture and services in question are tested with FSPG Pillows and the site conditions are within the application specification.
Upon installation make sure that you install the FSPG Fire Pillow length ways to the recommended installation method for the service you are installing around.
Install the FSPG Fire Pillows in such a way that all joints are staggered in each opening around the services to a minimum depth of 150mm. Always ensure that large voids are completely filled and FSPG Pillows are installed in a manner that ensures a tight compression fit.
Fill in any gaps with the smaller FSPG PIllows until there are no gaps. Always ensure that large voids are completely filled and fire pillows are installed in a manner that ensures a tight compression fit.

For floor

Install a 5mm mild steel mesh securely fastened to rigid floor.
Arrange FSPG Pillows in such a manner that they fully fill the penetration voids to a minimum depth of 150mm on the mesh.
When cable trunking passes through the seal ensure that the inside is filled with FSPG Sausage Pillows.